202 Led APA102 + 3 Zone pi-blaster

  • Hi,
    my new setup mostly finished:
    I hope you like it.


    Setup Main:

    • 202 LED APA 102 C(60LED/m)
    • Raspberry Pi 3 (LibreELEC)


    • MeanWell RS-100-5 (16A)
    • Basetech Video Grabber (UTV007)
    • selfmade 74HCT levelshift
    • CSL HDMI Splitter
    • WINGONEER Mini HDMI2AV


    Setup pi-blaster:

    • Raspberry Pi 2 (Raspbian)
    • 9x TIP120 transistor, 9x 580Ohm resistors


    • 12V 2A power adapter
    • 4m RGB LED stripe


    i switched to apa102 from ws2801 to get better colors and white

    Externer Inhalt www.youtube.com
    Inhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.
    Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.


    mounted on 5x20mm wood (the glue on TV is from my old Setup with ws2801)


    levelshifter is located below Pi


    the Pi Box


    hotglue and cable ties;)


    Case needed:D


    some cheap 12V RGB stripes+cablecanal+wires

    • Offizieller Beitrag

    The Additional LEDs with pi-blaster are so damn smooth that i had to look the video again to notice it! Very very good work!

  • Hey! I'm searching to create this sytem in my house. But after many searching...i found this subject, and i'm very interessing for your installation. I want to know if you can post your plan and take some few photos.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!