1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + LibreELEC Config-Error?

Discussion in 'Software Support' started by Bendix, 1 November 2018.

  1. Bendix

    Bendix New Member

    Messages:
    3
    Hardware:
    RPi3
    Hi,

    I am new to Hypercon and looking for help to use my RPi with LE to work as an ambilight.

    This is the logfile I get. I uploaded the config file via "send" with hypercon.


    The config file is here:
    ...

    Thank you for your help.
    Bendix
     

    Attached Files:

    Last edited: 1 November 2018
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    925
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    looks good, sure you uploaded it right?
     
  3. Bendix

    Bendix New Member

    Messages:
    3
    Hardware:
    RPi3
    Sorry for the late reply. After my RPi died without a reason it took some time to set up the new one.

    It's still not working. Here the logfile:



    And here the "new" config (with should be like the one above)

     
  4. Akriss

    Akriss Active Member

    Messages:
    355
    Hardware:
    RPi1/Zero, RPi2, RPi3, 32/64bit, +Arduino, +nodeMCU/ESP8266
    Looks like something (probably another instance of Hyperion) is running and using the port.

    Since you have a new Rpi, I would flash a fresh Libreelec to the sd card and reinstall Hyperion. The Libreelec dev's have there own version of Hypercon.
    I guess it has a more up to date install script for Libreelec, I would think but not sure.

    Found here : https://libreelec.wiki/hypercon#tab__windows
    And there install guild may be of help : https://libreelec.wiki/hyperion#tab__raspberry_pi

    Hope its of help.
     
    Last edited: 3 November 2018
  5. Bendix

    Bendix New Member

    Messages:
    3
    Hardware:
    RPi3
    Thx

    That's my newest logfile. Looks good, doesnt it? but the LEDs are still not working.

     
    Last edited: 4 November 2018