1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

BUG Confirming Hypercon bug report of Device settings not Loading

Discussion in 'Bug Reports' started by caveman, 29 September 2017.

  1. caveman

    caveman New Member

    Messages:
    18
    Hardware:
    RPi3, +Arduino
    Confirming Hypercon bug report of Device settings not Loading.

    Has this been resolved?
    I see the report listed from June 2016.
    Is there a reported resolution?

    Running V1.03.1 (11.06.2016)
    JAVA 8_144
     
  2. caveman

    caveman New Member

    Messages:
    18
    Hardware:
    RPi3, +Arduino
    After restarting HyperCon several times, it now seems that it loads partial configuration into the UI.
    The initial top block for Device on Hardware seems to only retain Type:. All other settings revert to default.
    Grabber/External and SSH seems to load with previous saved information.

    Tested the following to validate.
    - Cleared all current config files
    - Closed Hypercon
    - Opened Hypercon
    - Set and Saved configuration and settings files
    - Closed Hypercon
    - Opened Hypercon
    - Device block is reset except for Type: value

    So the main Device block does not load in saved values, but all other panels appear to be ok.
     
    Last edited: 29 September 2017