1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HyperionCon doesn't show the loaded settings

Discussion in 'Bug Reports' started by DeWe, 15 April 2019.

  1. DeWe

    DeWe New Member

    Messages:
    29
    Hardware:
    RPi3
    If I start HyperionCon (latest version) and I load the saved settings, which was converted and sent via SSH to the Pi, HyperionCon does not show in the GUI the loaded settings.
    E. g. Adalight : Baudrate, Output Port (TTYUSB0)....
     
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,208
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    HyperCon will not continued...sorry
     
  3. DeWe

    DeWe New Member

    Messages:
    29
    Hardware:
    RPi3
    Does another Program replace Hyperion?
     
  4. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,208
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    the webinterface which is built-in in hyperion.ng
     
  5. DeWe

    DeWe New Member

    Messages:
    29
    Hardware:
    RPi3
    Sorry about the stupid question, but I haven't found the answer in the IN
    What does. NG means?
     
  6. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,208
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
  7. DeWe

    DeWe New Member

    Messages:
    29
    Hardware:
    RPi3
    Thx, I have found this one before... but I didn't know what >>> *.ng <<<< means???

    Edit
    My mistake... now I understand.... >N ext G eneration <
    Thx
     
    Last edited: 16 April 2019