1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Using Trinket M0 as a PWM source?

Discussion in 'Hyperion Hardware' started by pyr0ball, 20 December 2018.

  1. pyr0ball

    pyr0ball New Member

    Messages:
    13
    Hardware:
    RPi1/Zero, RPi3, 32/64bit, +Arduino, +nodeMCU/ESP8266
    I've been struggling for a while to get an Arduino Pro Mini to work with my hyperion install, and thought I'd look for alternative boards, hopefully that could accomodate larger numbers of LED's (I'm setting up a whole room with backlit crown molding. coming in at 508 LED's). These are dirt cheap (bought mine for <$6) and pack 8x the storage and ram as the 328p.

    Wondering how much work might be required to port the adalight sketch over to circuitpython? I've got a little experience with vanilla python 2.7, but the most I've done with the Trinket M0 is flash pre-built binaries.

    If it goes well I may end up integrating one of these chips into the hyperion controller I'm designing to fit into a standard US wall plate complete with touchscreen and all. Based on this project: https://github.com/aderusha/HASwitchPlate

    Thoughts?
     
  2. pyr0ball

    pyr0ball New Member

    Messages:
    13
    Hardware:
    RPi1/Zero, RPi3, 32/64bit, +Arduino, +nodeMCU/ESP8266
    • Like Like x 1