Hi,
Im seeing that i need to change my pi's baud rate. Does anyone know how to do this on raspbian? in hypercon and arduino its set to 500,000... what do i change my pi to and how?
Thanks
Gershy13
Hi,
Im seeing that i need to change my pi's baud rate. Does anyone know how to do this on raspbian? in hypercon and arduino its set to 500,000... what do i change my pi to and how?
Thanks
Gershy13
I fairly sure for Hyperions purpose that the serial baud rate in set in only in the two places you mentioned, "in hypercon and arduino its set to 500,000"
However, I see lot's of good info from this link (https://www.google.com/search?…ud+rate&ie=utf-8&oe=utf-8)
I fairly sure for Hyperions purpose that the serial baud rate in set in only in the two places you mentioned, "in hypercon and arduino its set to 500,000"
However, I see lot's of good info from this link (https://www.google.com/search?q=pi's+baud+rate&ie=utf-8&oe=utf-8)
thanks, i was following this guide https://hyperion-project.org/t…-ws2801-ws2812b-apa102.8/
and at the bottom it says i need i need to do this.
- Now for the tricky part, we need to do a few steps to make sure the baud rate is high enough to accommodate the data being send from the Raspberry Pi to your Arduino
- First we need to increase the default baud rate on your Raspberry:
Im not sure how to do it in raspbian and what to set it to... maybe i need to do this only if im using an arduino and WS2812b leds (which i am)
Im not sure how to do it in raspbian and what to set it to... maybe i need to do this only if im using an arduino and WS2812b leds (which i am)
Yes, used when using a arduino and any LED attached to it.
The arduino firmware file (https://github.com/hyperion-pr…ino/adalight/adalight.ino) has some info in it about baud rate.
And in Hyperion's config it's here:
// DEVICE CONFIGURATION
"device" :
{
"name" : "new-test-1",
"type" : "adalight",
"output" : "/dev/ttyUSB0",
"rate" : 500000, <------------ Here
"delayAfterConnect" : 0,
"colorOrder" : "rgb"
EDIT: There is mentioned in that link in your post.
"
Code:
nano -w /flash/config.txt
Add the following line at the end and be careful not to adjust anything else:
Code:
#Increase UART speed
init_uart_clock=14745600
"
I missed that. I've not used that info with my setup. I'll have and try it out. my setup seems fine with out.
Hi guys,
Is this something I can do though the web UI or directly though SSH. What is the path?
Hi guys,
Is this something I can do though the web UI or directly though SSH. What is the path?
Through the WebUI, in Led hardware tab.
Thanks, I didnt have expert settings enabled. Seen all the settings once that was enabled
Is the Baud rate only on certain light controllers? I'm using WS281x and I do not see it, I am in expert settings
Is the Baud rate only on certain light controllers? I'm using WS281x and I do not see it, I am in expert settings
That is PWM (also audio pin) Pulse Width Modulation,
baudrate is only for SPI bus 》》 Serial Peripheral Interface bus
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!