SK6812 wechselt immer zu weiß zurück.

  • Hi,


    Habe heute meine neue Strip in Betrieb genommen. Diese bleibt die ganze Zeit auf weiß stehen.


    Starte ich ein Film oder ein einfaches blaues Bild zur Kalibrierung sehe ich die Farbe kurz bei den LEDs, nach so einer Sekunde wird die LEDs wieder weiß.
    Bei einem Film wechselt es sich die ganze Zeit ab.


    GND strip ist an GND Netzteil und RPI4
    Data in ist an MOSI vom Rpi4.


    Kann mir jemand bei der Fehlersuche helfen?


    Deine Version: 2.0.0-alpha.7-PR#935

  • Thx for the tip it fixed the issue with the full white led strip. Now I only have the following issues:

    • first led is always on and is not possible to change its color - always green (tested on hyperion.ng alpha 8 & 9)
    • leads blink with full brightness from time to time, once every couple of seconds


    Had you had any of those issues?

  • I was using level shifter with my previous setup to bump up voltage on the signal rail, but it turns out that it is not needed and was causing the problem. That + common ground and your setting fixed everything. Thx.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!