Seems that Nano uses the CH340 Chip which supports the following baud rates.
CH340 supports following baud rates: 50, 75, 100, 110, 134.5, 150, 300, 600, 900, 1200, 1800, 2400, 3600, 4800, 9600, 14400, 19200, 28800, 33600, 38400, 56000, 57600, 76800, 115200, 128000, 153600, 230400, 460800, 921600, 1500000, 2000000 bps.
The baud rate of 5000000 can be set in the Adalight Sketch, but apparently cannot be adjusted via WebUI. It was still possible via HyperConfig for the Hyperion Classic. 11520 is just too slow if you want to control 392 LEDs.
but apparently cannot be adjusted via WebUI.
Change the the "Settings Level" (via the wrench) minimum to "Advanced". Then you can set the baud rate.
Change the the "Settings Level" (via the wrench) minimum to "Advanced". Then you can set the baud rate.
After reading about the expert mode, I also found it and with it the settings for the baud rate. voila! Hardly you do it right, it works perfectly. 
Thank you!
Please, publish arduino nano sketch and your configuration of hyperion ng. I connect arduino nano to rpi 3. But there is no reaction. Led strip works with hyperion.
@HaStuR you allready get here a answer
https://hyperion-project.org/t…rion-ng.11397/#post-34857
please be patient and dont cross-post, thank you
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!
