Ok the issue the lights are flashing but not following the color on the screen. Is there something I need to do to fix this issue
Pi GPIO Pins
- Arrow.slingr02
- Erledigt
-
-
yes, did you setup your LEDS in Hyperion Dashboard?
are you using Hyperbian, LibreELEC or a manual install?
-
Hyperbian. Now the LED's are working but they just flashing crazy and not following anything on the TV
-
so maybe a chance they are running an effect rather than using any capture device?
if you have setup your LEDs in the Configuration -> LED Hardware section (both tabs)
double check your capture devices are setup platform or usb capture.
Sounds like you don't have something setup correctly though, so the more info you can post the better chance of someone being able to help you
-
ok I have everything configured. It is show the input and it is show I have video in. It looks like everything is up and running correctly but all the LEDS do is randomly flash.
-
I am using a Pi 4 with a usb capture card.
-
could it be the LEDS are not compatible?
-
could it be the LEDS are not compatible?
What leds and controller are you setup with?its PWM then turn off audio in config.txt, controller then used is ws281x
Also check PSU , maybe voltage to high or else you are not having a GND to common ground to LEDstrip PSU and Raspi
-
here is the hardware I have purchased. I am sorry to be asking help but this is the very first time I have done anything like this so I am trying to follow all the directions. so if anyone has a step by step setup and a way to test it all before I but it on my TV I will take all the help I can get.
-
what model of Pi4 do you have?
-
it was given to me so it is a B
-
-
it says 3.5 so I am going to assume it is a 4gb
-
yeah, at least Hyperion supports that model
Do they work as expected if you manually control them via the Remote Control section -> Colors/Effects , that colour picker should make them light up the colour you select.
Quite hard to say of the match the tv when they are not fitted or defined, ie 60 top and bottom and 40 on each side
The file @jeroen warmerdam mentioned is located at /boot/config.txt and check if this line is there dtparam=audio=off
-
They work when they just have a manual controller attached to them. when they are connected They are just randomly flashing
-
ok it shows that it is on so how do i turn it off
-
ok I got it turned off but the LED's are still doing the same thing. any other ideas. the standby is on green mood blobs and it is still flashing crazy
-
if the colours are working as expected - crack on
It may look like random flashing on the roll but when placed on the tv then position, rotation and starting position defined in Hyperion to match, it could be the pattern its taking from the capture device, point is you cant check it against anything apart from a solid colour until its fitted
-
ok it is still not responding the way it is suppose to. Anyone have any other ideas. I have done everything everyone has told me to do but still not able to get it working. I have even did a fresh install and that did not work either.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!