Switched to hyperbian 10, same settings as 9 using ws281x and no LED response
- james2brite
- Erledigt
-
-
wise choice man , increase the settings level and enable logging, should hopefully give you a better idea of where its going wrong
-
-
logs
-
pclin I have zips of 9 and 10 I just thought it would be better to start with a clean install, and found the suggested thread after.
TPmodding it is same issue that pclin linked above this link, I needed to disable audio on config file and root pi (rooting pi also enabled access to UI which I lost on alpha 10 install)
Thanks Guys
Edit, I am getting it set back to default and not pick up usb signals again. do i need to add command after to fix root ect?
-
james2brite
Hat den Titel des Themas von „Switched to hyperbian 10, same settings as 9 and no LED response“ zu „Switched to hyperbian 10, same settings as 9 using ws281x and no LED response“ geändert. -
if you followed pclins link, and changed the service files from user pi to root then it should always start with root
-
OK thanks, am trying libreelec now as I think switching to wled will solve alot of other problems too
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!