hello
I have pi zero + hyperbian + ws281x work fine gpio18 On alpha 9
But not working on alpha 10 with the same configuration
When change GPIO18 PWM to GPIO10 SPI it work but with blinking some leds.
hello
I have pi zero + hyperbian + ws281x work fine gpio18 On alpha 9
But not working on alpha 10 with the same configuration
When change GPIO18 PWM to GPIO10 SPI it work but with blinking some leds.
thank you it worked nice
I have problem when screen on purple color but on led it is blue color why
I have problem when screen on purple color but on led it is blue color why
I think it's the RGB order. Change it to GRB or otherwise.
the ordre on my config is GRB ( green is green, red is red, blue is blue)
the problem is
the color on screen yellow but on led green
the color on screen purple but on led blue
only this two color have problem
if you are sure in the hardware compartment everything is okay ? then maybe power drop in the ledstrip and/or to much resistance in the wiring and connectors. Check also connections and power the LEDstrip if possible from both sides
You can try to increase the baudrate setting of the SPI led controller
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!