Led strip not lighting up

1. offizieller Beitrag

    used a 5V 5A Power adapter + raspberri pi zero w + ws2812b 60led/m 5m strip . tried to test it before connecting to a capture card. the first light is only working , sometimes all the lights power up but never again
    i have attatched the setup and hyperion config

    SETUP


    CONFIG for testing


    1.) Try to make a additional GND connection from RPi→LED connector.

    If that not works you need a level shifter.

    That's for 4-wire-LEDs, so for WS2812 you need only one channel.

    Grüße aus Österreich / Greetings from Austria !

    - Don't wanna miss it anymore !

    The power supply is not the problem. A level shifter push the data signal to the correct level for the LEDs.

    Zitat von Mike72

    Try to make a additional GND connection from RPi→LED connector.

    Did you do this?

    Grüße aus Österreich / Greetings from Austria !

    - Don't wanna miss it anymore !

    Einmal editiert, zuletzt von Mike72 ()

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!

Benutzerkonto erstellen Anmelden