Using tilted aluminium profile for LEDs?
- stiray
- Unerledigt
-
-
LED above + LED side + half of the LED below.
regards pclin
-
pclin: that part was simple, trying to figure out where to enter it was far more complicated
Also ideas for improvement:
- define first light and direction by clicking on layout
- on click turn on desired right on layout (eliminates the need to count the LEDs, click and check if the light turned on is the right one)
-
Hey!
Thanks for the photo stiray
I think using the 45°-angled profiles paid out as the light is spreading wider around the TV.
What do you think?
Do you like it?And sorry for asking again:
- 1) How close are the LEDs to the outer edge of the TV now?
Now, as your setup seems to run without problems ...
- 2) Can you make another photo with uniformed colors, like in the example photo?
The "rainbow effect" is kind of distracting ...
Or maybe make a short demo-video playing a movie?
Again, thank you very much ...
-
Sure, just to get home...
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!