Protoserver error

  • Hi, I've recently updated my hyperion to the new version. I used the 1.03 version until now and it was working fine. Now I have a problem when I try to send data throught proto-port. I recieve the next message constantly, which only apperars when I send some data:


    2021-12-28T17:40:12.922Z [ PROTOSERVER] (ERROR) Previous line repeats 200 times
    2021-12-28T17:40:21.721Z [ PROTOSERVER] (ERROR) Previous line repeats 200 times
    2021-12-28T17:40:30.435Z [ PROTOSERVER] (ERROR) Previous line repeats 200 times
    2021-12-28T17:40:39.199Z [ PROTOSERVER] (ERROR) Previous line repeats 200 times
    2021-12-28T17:40:47.867Z [ PROTOSERVER] (ERROR) Previous line repeats 200 times


    I have hyperion running in a rasperry pi 4 and I send video data throught Hyperion Grabber. Leds work fine, I've tried them with the effects mode in the web server.


    Any solution to my problem??.



    Thanks.


    Hi again, I aswer to myself. I've found the problem. This message from systemd showed me the way:


    Dec 28 20:15:35 raspi4 [6762]: The priority 50 is not in the proto-connection range between 100 and 199.

    Dec 28 20:15:43 raspi4 hyperiond[6762]: 2021-12-28T20:15:43.776 PROTOSERVER : <ERROR> Previous line repeats 200 times

    Dec 28 20:15:43 raspi4 [6762]: Previous line repeats 200 times

    Dec 28 20:15:52 raspi4 hyperiond[6762]: 2021-12-28T20:15:52.343 PROTOSERVER : <ERROR> Previous line repeats 200 times

    Dec 28 20:15:52 raspi4 [6762]: Previous line repeats 200 times



    I've realized that protoserve doesn't accept priority values under 100 and above 199 and I had put the value on 50.


    Problem solved!!.


    Thanks.

    2 Mal editiert, zuletzt von RockFer () aus folgendem Grund: Merged a post created by RockFer into this post.

  • Thank you for your quick reply.


    My source is a Raspberry with OSMC+Hyperion. I don't have this kind of tools... I already tried to modify the hyperion.config.json by adding "priority" : 150 in the protoServer section but without success...


    Any advise ? thx

    • Offizieller Beitrag

    I already tried to modify the hyperion.config.json by adding "priority" : 150 in the protoServer section but without success...

    1. If you use hyperion.ng there is no hyperion.config.json.
    2. As Ambientheater77 already outlined, you need to set the priority at the sender side, not at Hyperion.

  • 1. If you use hyperion.ng there is no hyperion.config.json.

    2. As Lightning-guy77 already outlined, you need to set the priority at the sender side, not at Hyperion.

    1. I use hyperion, not hyperion.ng

    2. In fact I have two Hyperions : One on OSMC which is the sender and one on my ceiling with another raspberry pi and Hyperbian.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!