can anyone help me out with how to check programing code. i have tried on multiple sd cards. a pi 4 and pi 3. I have downloaded hyperbian on one card i tried using ras pi os with install of hyperion and followed different videos and post , nothing has worked yet. been at this for a week now. i am a super noob at programing and have a bit of knowledge when it comes to circuits. my led strip is ws2815 12 volt leds. 12v 8a power supply which is over the amperage required for this strip. i have also installed logic level board in the setup. capture device is working. i can see it when i log into the ip address on hyperion . i configured hyperion to my setup unless there is something on it thats blocking the lights. im getting frustrated . i have entered "sudo updateHyperionUser -u root" and checked config.txt for dtparam=audio=off please help
Debug log please.
i have entered "sudo updateHyperionUser -u root" and checked config.txt for dtparam=audio=off please help
make sure you are using the PWM ledcontroller, setting WS281x, GPIO18 default. (hardware PIN 12) https://pinout.xyz/pinout/pwm
can u make a picture from the Logiclevel board and PI? If you have i have the right schematics for you how to connect
# For more options and information see
# Some settings may impact device functionality. See link above for details
# uncomment if you get no picture on HDMI for a default "safe" mode
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
# uncomment to force a console size. By default it will be display's size minus
# uncomment if hdmi display is not detected and composite is being output
# uncomment to force a specific HDMI mode (this will force VGA)
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
# uncomment for composite PAL
#uncomment to overclock the arm. 700 MHz is the default.
# Uncomment some or all of these to enable the optional hardware interfaces
# Uncomment this to enable infrared communication.
# Additional overlays and parameters are documented /boot/overlays/README
# Enable audio (loads snd_bcm2835)
# Automatically load overlays for detected cameras
# Automatically load overlays for detected DSI displays
# Enable DRM VC4 V3D driver
# Disable compensation for displays with overscan
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
hyperion set to ws281x and connected to gpio 18
ok so i changed it to gpio 13 and its started to work, only problem is it starts to freak out .. goes intolike dance mode then works then dance etc.
any help on this
More information, pictures etc.