I hooked it up to GPIO 10, enabled SPI on the raspberry pi, made sure all connections are correct. However, the leds just keeps individually changing to random colors with seemingly no control every time I would boot my rpi. The rpi uses Hyperbian, and has all packages updated. Every time I boot into Hyperbian, the Hyperion status is always "Stopped". I tried running effects through the configs, but they do not respond. I’ve also tried using screen capture with Hyperion Screen Capture, but it has no response either.
Sk6812 cannot control
- brownbear
- Unerledigt
-
-
TPmodding
Hat das Thema freigeschaltet. -
it seems you are missing common GND
lay a wire ( -) from your barrel connector that's connected to the LED's to a GND PIN of the Raspi, any ground PIN will do ( if you can do 2 ground PIN even better)
Ground at Raspberry Pi GPIO Pinout
also increase LED settings Connection Attempts to the default of 12
Use GPIO10 for SPI ( hardware PIN 19)
second of all, if possible solder all connections
- power from both sides GND separate and +5 volts separate on begin and end of ledstrip ( if possible in your setup)
- increase the PSU +5volts to +5.3 volts
- loose the barrelconnector and use Wago's or anything thats not causing resistance like soldering on your PIN's directly, those jumpercables are known to mallfunction ( having resistance) on data PIN ALOT!
goodluck!
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!