Hi, sort of new to this. I currently have Hyperion running with my Philip's Hue lights and that's working fine. I have a pixel controller that i use with falcon pi player for a Christmas light show (very basic, still learning) in the off season i figured i'd try and use the bored with some of the extra lights i have with hyperion. However i couldn't really get it to work and i'm not sure it it would at all. The Pi Hat(cape) i'm trying to use with my Pi4 is the M4-Pi from Microcyb. Any suggestions on what settings to use to set up the lights on? The lights are ws2811's for what it's worth. Thanks in advance for any help.
Pixel Controller
- LostElric
- Unerledigt
-
-
Which controller is connected to the WS2811 (link).
regards pclin
-
So the WS2811's are plugged into the M4-PI which just sits on top of the GPIO pins. Specifically they are in port one on the controller. M4-PI link.
-
OK, and what device is Hyperion running on?
regards pclin
-
It's running on a Raspberri Pi4, 4gb.
-
I took a quick look, it works with XLights, so i think it should work with Hyperion too, create a new instance in Hyperion and select E131 or DMX then configure the instance, appropriate settings in FPP, then the leds should light up.
regards pclin
-
Oh awesome. I'll give it a try. Really appreciate the help and insight. I'll update with results once i'm able to test. Thanks again.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!
