So here is where I am at. I followed your advice and installed the Hyperbian feast to use image on an sd card. I put it in my pi 3B+ and powered it up. Went to Bitvise that I am using for my ssh and connected. Opened a terminal and saw the Hyperbian page. Then I opened my Edge browser and typed in “http:// the ip address I got from my router :8090” and hit enter. Nothing. Says nothing found.
I must be doing something wrong because it shouldn’t be this difficult. I have set up my Magic mirror and my Home Assistant with no issues.
When I was installing the image I did it on a few different sd cards. Just in case.
I tried powering down my pi inserting a new sd card and starting over again. Now my pi does not connect to my WiFi at all. Frustrated 😩