Blacklist Leds not applying to Led strips
-
yellow_gambit -
May 22, 2025 at 2:45 AM -
Thread is Unresolved
-
-
use a new instance and remove the old one, that did it when is was diddling with blacklist
-
use a new instance and remove the old one, that did it when is was diddling with blacklist
Still not working

-
- Official Post
Try to blacklist maybe number 10 to see if that works.
Btw. which version are you using?
-
version 2.0.16
when i manage to get it working and do the wrong ones, theres no way to undo them even if i clear the rules..those leds just stay off
-
count them with your fingers/eyes. then write the numbers down and use a new instance.
i had the same problem, blacklisted leds in 2.016 build you can't unlist and stay off.
only possibility for me was to count them and program them into a new instance after rebooting.
goodluck!
-
Does blacklisting change the Generated/Current LED Configuration Textfield?
If not you can try to edit it manually.
-
- Official Post
when i manage to get it working and do the wrong ones, theres no way to undo them even if i clear the rules..those leds just stay off
Remove the blacklist rule that is not required.
The click on the "Classic Layout" Tab.Then save.
The LED should be back.
Note: The LED counting starts with Zero.
If you want to blacklist the last LED you need to put LED-count-1As the blacklisting works with low LED numbers (but not with the end of the strip), you should check your LED couunt and layout configuration.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!