Custom LED sorting in layout?

    Hey guys,
    I designed my first WLED project around SignalRGB but the toll on my GPU was too high and I switched to your super nice project hyperion.

    Because its my first project I soldered two stripes into the square behind my TV. So its left > top and bottom > right over one WLED ESP32 controller.
    Now I have the problem that I dont get the stripes to match in the classic layout mode. is there a possibility to rotate single stripes like I saw in a HyperHDR screenshot.context.jpg


















    I would really like to avoid desoldering the stripe and changing its direction into a single big stripe(did not know better back then)

    Thanks in advance

    Hi Georodin,


    of course you can do that! :)

    You just have to adjust input position (starting point), gap position and gap length.

    Here i made an example for you:


    If you have less leds on bottom than top (because of the gap) you have to

    decrease the bottom leds count (bottom leds = top leds - gap length)


    Best regards

    Pi4 | LibreElec | Hyperion 2.1.2-beta.1+PR1884 | Rudihorn's DRM-VC4-Grabber | SN75174 Driver | SN75176 Receiver | WS2812

    Edited once, last by Marxon ().

    Hey thank you for your quick reply and support.
    Worked, had to reverse one of the stripes in the WLED setup and increase the corner % to like 4%.
    Thank you again

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login