Raspberry w/ Hyperion + Ambilight Kit

    Hello everyone!


    I have now looked at the topic Ambilight again and would like to start a new project. So far so good. I still have an old LED Ambilight kit from AliExpress with an Arduino Uno Box. The LED strips are connected by cable without soldering. Just have a look here: https://de.aliexpress.com/item/32900964704.html
    Isn't it possible to use Hyperion via the Raspberry (with HDMI Grabber and the whole other stuff) and connect it to the Arduino box? Then you could save soldering the LEDS to the Raspberry.


    HDMI --> splitter etc. --> Raspberry with Hyperion --> Arduino Box (from the kit) --> LED (from the kit) WITHOUT soldering


    I hope you understand what I mean. I'm happy about every suggestion for a solution.

    Bump old thread..

    i have this setup and used it to my nvidia shield but i want to use hyperion instead.

    i have cut the data cable and inside is a red and white cable.

    should i just presume the white cable is the data cable and connect it to my pi?

    and what is the red cable?

    i rather not unmount my tv from the wall to figure it out :P

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!

Benutzerkonto erstellen Anmelden