Hey guys! Ultra newbie here with Hyperion and LED strips. I got the SK6812 RGBW and I'm having similar issues than the described here.
At some point I was able to make it respond using SPI , but when I connected the capture card I had some issue with the SPI (was disabled and I couldn't start it) so I reinstalled everything and I got it connected but having the original issue, only having white leds turned on.
I've set:
Code
# Enable audio (loads snd_bcm2835)
dtparam=audio=off
[pi4]
# Enable DRM VC4 V3D driver on top of the dispmanx display stack
dtoverlay=vc4-fkms-v3d
max_framebuffers=2
[all]
#dtoverlay=vc4-fkms-v3d
dtparam=spi=on
core_freq=500
core_freq_min=500
Alles anzeigen
and
Code
console=serial0,115200 console=tty1 root=PARTUUID=27305f52-02 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait spidev.bufsiz=1024000
So far, the only thing I've been able to get is the white LEDs flickering every second.
I've tried PWM as well on GPIO 18, with RGBW protocol on, no luck either
Any idea what else can I try?