so ive installed this version 2.0.15-beta.1+nightly20230117fa7a5b6 and i still cant see segments for what i need
Beiträge von Franky118
-
-
so the 1st segment are for my shelves and second segment is the tv leds
-
Thanks for the reply guys but none of that makes any sense to me 😂😂
Have you got a noobies guide
-
so basically I’ve got WLED controlling leds for shelf lighting and now I’ve wired it upto the tv aswell
I’m using a dig uno and have the shelves on channel 1 and the tv leds on channel 2 but when I goto use Hyperion it controls the whole lot I only want it to control channel 2
Is there a way to set this in Hyperion?
Or even In WLED to only control channel 2 when hyperion is in control
-
Ok so Ive replaced the raspberry pi and it’s a lot better now it’s basically working now apart from the odd flash of like rainbow colours every ten seconds or so
I’ve soldered the data line to gpio 18 and have 3 grounds connected also which are not soldered
What is causing the random flashes
-
So Ive tried other gpio pins and none of them are working so Ive come to the conclusion that the pic itself is faulty,
I bought it second hand from eBay
I’m going to get another pic and maybe a new set of leds also
Thanks for the help guys much appreciated
-
I know this already
total leds is 276 total configured pixels in Hyperion is 30 top and 30 bottom and 16 on left and 16 right so total 92 pixels
It’s still flickering with 3 ground pins connected although it’s not flickering as much it’s still happening
Hi do I rewrite the time settings you mentioned
-
Leds are 60/m
How do I do this
Try rewritetime setting on 6000
-
So I’m running ws2811 leds 60/m so obviously more leds so 92 pixels
Power supply is plenty power full i over sized it as it’s running leds in my shelves next to the tv also It’s a raylax 300w 25a psu
-
Right ok so where do I go from here then if it isn’t that
-
I already had the ground connected thanks for replying though
It is strange though how it’s flickering as the data wire from the pic is only about 10cm long and it flickers crazy amount the length of the leds is nearly 3m in total so that’s why I’m assuming I need a logic level shifter
-
Ok so I think I’ve figured it out the dtparam audio was on and Ive set it to off now
So my next issue is it’s flicker like crazy so I’m assuming I need a logic level shifter so Ive ordered some
-
Yes grabber is working I can see the screen capture in Hyperion and what the leds are supposed to be doing but the leds are stuck on the boot effects
The leds have frozen though like half way through the effect
-
Debug log in attachment
Hyperion picks up the tv signal but about half way through the boot the lights light up and then freeze and then I can’t change them so I’m assuming it’s software related rather than hardware
-
Just setup Hyperion on rpi a+ and once it boots it displays the boot effect then just hangs and leds don’t change just stays solid on the boot effect , I can’t even do the rgb boot wizard as the colours don’t change
Help would be greatly appreciated