Posts by zolive

  • Hyperion Android Grabber ne fonctionne pas

    Bonjour.

    Le message date, mais au cas où une personne qui passe dans le coin, rencontre le même souci :

    Quand vous utilisez "Hyperion Android Grabber" (c'est mon cas pour sur la Shield Pro, pour les films), il envoie les données au serveur ( il se trouve sur mon PC, c'est idem si vous l'avez installer sur un autre support) pour les jeux et films via la Shield Pro)

    - Capture matérielle doit être décoché.

    Si vous ne le faites pas, Hyperion attend les données sur le support dont il est installé.

    - Pour Hyperion Android Grabber, sur votre android, vous devez entrer l'ip où se trouve le serveur Hyperion, et le port, c'est lui qui va envoyer les données.

  • Configuration Transfer 2.0.16 -> 2.1.1

    Thank you very much!


    Here’s the log:

    It’s a shame, because I’d be disappointed to go back to the old version — you’ve done an amazing job since then, and the program now uses much fewer resources.

    PS: I noticed something — in the old version, as long as the program couldn’t detect all the WLEDs, it would close.

    With this version, it launches even if it doesn’t detect all the WLEDs.

  • Configuration Transfer 2.0.16 -> 2.1.1

    Thank you for your reply, and sorry for the delay…

    I did copy the configuration folder from the old PC, and it works, but I still have the same issue:

    • When I launch Hyperion on my new PC, one of the LED strips (the one on the TV stand — there are 4 in total) flickers, and another strip (the ceiling one) no longer works.

      To fix the issue, I have to, at each startup, go into the settings and enable/disable it in Remote Control → Component Control → Disable then Re-enable LED Device.

    Please note that each LED strip has its own WLED. This worked perfectly with the old version of Hyperion, no issues at all.

    Thank you for your help, and have a great day !

    édit: Joint vidéo

    video

  • Configuration Transfer 2.0.16 -> 2.1.1

    Hello !
    I’m using Hyperion from my Windows 11 PC, and after buying a new PC, I want to transfer my Hyperion configuration to the new machine.

    However, I’m moving from version 2.0.16 to version 2.1.1 of Hyperion, and the web interface tells me the configuration transfer is incompatible between these versions.

    The problem is, I spent a huge amount of time fine-tuning the configuration for four WLED LED devices (yes, that’s a lot… ^^).

    Is there a way to transfer at least the WLED configurations, for example by copying just that section into the configuration file of version 2.1.1 ?

    Thank you very much.