Thank you this solved the issue
Posts by Fullbit
-
-
"Hyperion Settings level Expert and check the hardware settings of the grabber.
Press Default hardware controls"
Doing this solved the video capturing issue, thank you!
The only issue I face now, is that when there is no data, I get a rainbow screen like the one below.
I assume it's the USB doings?
This is the usb
-
Hey everyone,
I have the following setup
Chromecast 4k into an HDMI splitter (1-in 2-out), that support up to 8k 60hz
One HDMI into a 4k Samsung tv, works just fine including CEC
The other HDMI goes into a UGREEN USB HDMI capture card (model: CM489), it goes into a raspberry pi 5 (4gb) with Hyperion
On Hyperion the USB is recognized but only shows a black image in the live view, I tried almost all the settings but still the same.
Things I tried:
- Lowering the Chromecast resolution to 1080p 30hz
- Connected the USB into a laptop with OBS, managed to capture the image with no issues (MJPEG, 1920x1080, 30fps)
- Changed the USB power settings on the PI (set usb_max_current_enable to 1)
- Took an image from the pi (tried a few jpg and yuyv, both jpg could not be viewed, possibly corrupt, the yuyv showed a black image as well
I am not sure what else to try, any advice would be helpful!
Thank you all!