Alles anzeigenFirst try worked
Have even a live picture in the Web-Interface.
Only Problem: i get a repeating Error when starting:
root@raspberrypi:/home/pi# hyperiond
[hyperiond DISPMANXGRABBER] <ERROR> Snapshot failed: -1
[hyperiond DISPMANXGRABBER] <ERROR> Previous line repeats 200 times
Any hints about this?
But the grabber seems to have a new driver in buster - its now YUVV instead of MJPG?
So the i´ve not tested the MJPG issue...
Video input : 0 (Camera 1: ok)
Format Video Capture:
Width/Height : 1920/1080
Pixel Format : 'YUYV' (YUYV 4:2:2)
Field : None
Bytes per Line : 3840
Size Image : 4147200
Colorspace : sRGB
Transfer Function : Default (maps to sRGB)
YCbCr/HSV Encoding: Default (maps to ITU-R 601)
Quantization : Default (maps to Limited Range)
Flags :
Crop Capability Video Capture:
Bounds : Left 0, Top 0, Width 1920, Height 1080
I bought the same hardware (VGB500 Grabber) and was about to send it back when I stumbled upon your message.
I have the same setup: Raspberry Pi 4 and `hdmi_force_hotplug = 1` in /boot/config.txt.
Raspbian Buster is fully up to date too.
I tried installing hyperion.ng in its latest version, but can't seem to make the grabber detected.
Would you mind sharing your config ?
Edit: Actually managed to make it work
I am not sure exactly what was the issue, I couldn't get the module uvcvideo, modprobe was throwing errors.
I installed libuvc0-devel just in case.
In the end, I rebooted the Raspberry and everything was detected properly.
As far as my early tests went, it works perfectly with Kodi on one side and the PS4 on the other.