Beiträge von Efunch

  • USB Capture not staying activated

    I had that happen to me on my first Hyperion install, with a similar capture card. It turns out that my pi was having some under voltage issues due to a bad voltage regulator. That power supply might be a little weak for the pi and the capture card, maybe a 3 or 3.5 amp, but I'm just speculating. Although this probably has nothing to do with it, what are you using to power the leds?

  • Can't connect to browser interface

    Hello Jeroen, I tried typing hyperiond into terminal on Putty and this is the error that I got.


    [hyperiond MAIN] <ERROR> Hyperion Daemon aborted: std::bad_alloc
    [hyperiond MAIN] <ERROR> Hyperion aborted: std::bad_alloc
    Segmentation fault


    The method that I used, which was Dr.zzzz's method on Youtube(

    Externer Inhalt www.youtube.com
    Inhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.
    Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.
    ), must have missed some steps. The first thing that I noticed was that putting my wifi info into the wpa_supplicant.conf file didn't automatically start the pi's wifi, so that I could ssh into it. I had to plug the pi up to a screen, so that I could use the sudo raspi-config to start wifi and get an ip address. I do remember that the first time that I installed Hyperion, using Dr. Zzzz's method, was on a pi 3 that later went bad due to a bad voltage regulator. At first I couldn't get the GUI on it either, but I found a thread somewhere about some different commands being sent during installation, that solved it and I was able to get the GUI going. Sadly, I can't remember where or how I found that thread.

  • Can't connect to browser interface

    I am stumped. I have installed Hyperion.ng on Raspberry PI 3 several times, and I can ssh into it, but I can't connect to its browser interface at all! All browsers that i've used are supported. I've followed every step to the letter. I first tried on a Pi 3 and no web interface. I then installed Hyperion.ng on a raspberry Pi 4 and again, no web interface. I have no idea what is wrong. Can someone please help me get past this first hurdle?