Yes you should be able to be up and running with what you have and pin 12 should work the same as pin 18 would. do you have this in your...
Yeah @Wim on the ESP8266, you could then just install Hyperion on your other Pi wherever it may be and as long as the other D1 mini or ?? is on...
o_O:facepalm: Good Luck @TPmodding :D
On this occasion it may have been a whole lot easier to put a jumper in that plug and run them straight from the GPIO :)
yeah @RCHudspeth , may be useful to switch the log level to debug, save it then reproduce the white flashing and see what shows in the logs, if...
got a link to it?
if you boot the pi with no usb capture and try the effects does it still happen?
ive ran it 3 of the GPIO pins and never had any white flickers, Touche on the GPIO pinout, thats my fav 1 :thumbsup: , Im with @jeroen warmerdam...
you are hard work @luckyjacks , you could have mentioned that long before now,...
Your chasing the wrong fault @luckyjacks , vendor preset: enabled will not solve your problems. @TPmodding has gave you the working sketch - this...
with it flashing white occasionally id be looking at signal rather than supply, did you connect the earth of the LED strip to the Pi GPIO also?
Good Luck Tony
Last message got deleted but thatnks for the links @TPmodding :thumbsup: Ended up going with the default Hyperion FastLED as it scored good and...
unsure if any are 12v but here's a list, even to give you led codes to google https://hyperion-project.org/threads/which-led-is-the-best.35/...
There's numerous workarounds @Tony P , the ubuntu 64 image you had earlier, is that the Home Assistant base o/s? Have you tried flashing the...
Tbh @Tony P IMO a full blown Ubuntu 20.10 on aarch64 is a big resource hog and could be problematic as you can see just now, Quick way would be...
ahh my bad, yeah it looks like you installed a Ubuntu x64 image, what do you get from this one cat /etc/issue
Easiest method would of been Hyperbian then install home assistant but each to their own. looks like your trying to install the wrong version...
appreciate the comment @wladi , Your pcb looks sweet, very clean :thumbsup:
Thats above my paygrade @Lord-Grey :roflmao: and could be his problem, I think he is using the same mode if i remember his screenshots correctly....
Separate names with a comma.
