1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Color Channel Adjustments - Typical Settings?

Discussion in 'Hyperion General' started by The, 26 July 2019.

  1. The

    The New Member

    Certainly everyone's color channel adjustment setup is going to be a bit different. I'm somewhat curious on typical experience. I've a got a light gray wall (Repose Gray from Sherman Williams paint, SW 7015) behind my TV. I'm using a 5 inches short of 5 meters of WS2801 LEDs from AliExpress. My Hyperion.NG calibration settings are shown in the attachment; far from perfect, but as close as possible for my TV/wall.

    • White is calibrated somewhat pink rgb(255,160,150)
    • Yellow is calibrated a burnt orange rgb(200,100,0)
    • Uncalibrated-raw-yellow appears very green.
    • Red is certainly weak/dim when shown next to other colors.
    • Yellow is really weak/dim, probably due to how much calibration was done on it
    • I'm betting my green and blue burn hot/bright.
    • Betting red burns dim
    If I were to invest in some different LEDs for better colors, where should money be spent?

    Attached Files:

    Last edited: 26 July 2019
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    thats the "problem" of rgb leds...there is no w for the "pure white" you would need rgbw leds, but those are not supported right now..
    • Like Like x 1