Correct Arduino Sketch for 300 pixel WS2812B LED strip

  • Hi all, first post. I followed the official DIY guide here:
    [DIY] Amblight project/guide - Hyperion - WS2801/ WS2812B / APA102


    I got everything working for the most part using the example adalight_ws2812b sketch from the guide (see below). The problem is I'm using a 300 led strip, but when I set #define NUM_LEDS to anything greater than 240 I get no output other than the initial RGB flash when starting powering up the arduino. Leaving it at 240 or any number below works up to the number of led's defined. I've tried several other sketches, but no luck. Hoping someone can point em in the right direction.


    Thanks!




    Hyperion Config (trying to use 284 of the 300 leds on the WS2812B Strip)

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!