1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOLVED Hyperion NG help please to setup 2 AtmoORB

Discussion in 'Software Support' started by RKF, 23 June 2020.

  1. RKF

    RKF New Member

    Messages:
    9
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    I have been using a single AtmoOrb with great success on Hyperion NG

    But I would like to consider a "stereo" AtmoOrb setup with Orbs mounted left and right.

    I'd like to know how I set up two devices with two different scan areas within the web UI.

    Specifically, if I have two Orbs with 24 LEDS, I can use the LED page to setup "Left" 24 LEDS, and "right" 24 LEDS, but how do I tell NG to send the signals to the correct Orbs ID?

    Edit:
    I'm using WS2812 rings each containing 24 LEDs - I connect these to an 8266, and I don't care what typer of UDP is used. I chose the AtmoOrb because they can use multiple ID's to hopefully get the Left / Right assignment.

    Thank you!

    Edit - Figured it out:
    Simply configure another instance - Configuration > General >LED Hardware Instance Management. Run them both at the same time.
     
    Last edited: 25 June 2020