1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

X86/64 Hyperiond requires a restart to work properly

Discussion in 'Software Support' started by WitchDoctor, 23 May 2020 at 21:51.

  1. WitchDoctor

    WitchDoctor New Member

    Messages:
    2
    Hardware:
    32/64bit, +Arduino
    hi,
    I am using the following setup:
    - X86/X64 running Linux Mint
    - Kodi which autostarts when machine boots
    - string of WS2813 Leds contolled by Arduino Uno plugged into the linux mint machine
    - ledstrip is powered by mint machine power supply via Molex cable

    Problem:
    When I start the machine the leds light up briefly, then die out.
    Hyperiond is running from the log, but requires sudo Hyperiond restart to function properly.

    hyperion Log after normal start


    hyperion log after reboot:


    hyperion.config.json


    arduino sketch:


    after a restart of the hyperion service it works perfectly, but I have no idea what is going wrong at first boot.
    At first the grabber wasnt starting but I solved that by adding it to the linux auto-startup.

    Your help is appreciated
     
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,574
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
  3. WitchDoctor

    WitchDoctor New Member

    Messages:
    2
    Hardware:
    32/64bit, +Arduino
    its not mentioned in the tutorials and I see the release is alpha5
    is the functionality the same and is it stable enough to use?

    if you recommend me to switch I will give it a try.

    Do I need to uninstall the current hyperion version that I am using including the X11 grabber?
     
  4. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,574
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    just give it a try