1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ISSUE LEDs not triggering, even though Hyperion detects Arduino, and not sending errors

Discussion in 'Hardware Support' started by TJ Rob, 22 November 2020.

  1. TJ Rob

    TJ Rob New Member

    Messages:
    6
    Hardware:
    RPi1/Zero, +Arduino, +nodeMCU/ESP8266
    I have Hyperbian with alpha 9 running, and the USB grabber is working fine, the Arduino I put the usual code, and the lights trigger on the startup of the Arduino. The RX light on the arduino is lit up, which leads me to believe it's taking in data commands from the Pi. I don't believe I have any errors from the Log. Can I get some assistance?

     
    TJ Rob, 22 November 2020
    #1
  2. Lord-Grey

    Lord-Grey Moderator Staff Member Developer

    Messages:
    262
    Hardware:
    RPi3, 32/64bit
    Lord-Grey, 23 November 2020
    #2