Hello all,
I have a NodeMcu ESP8266 ES-12E board that I use with the ESP8266 Hyperion LED Controller library. It works very well. And in constructing one pixel bar, it peaked my curiosity in how far I could Bling my Hyperion setup.
So I ordered a bunch of Wemos d1 mini's. In anticipation of fabricating a bunch of remote pixel bar's. However I'm unable to get them to work and could use some advise please.
The sketch I used for the Wemos is the exact same I've used with the 12E board without problems. However it not working properly on the Wemos. The output from the serial console just loops this:
Code
ets Jan 8 2013,rst cause:2, boot mode:(3,0)
load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v3de0c112
~ld
øI: Start logging
I: Configuration read at 0x0 with v3
I: CFG=EEPROM config loaded
I: Reset Mode
I: Connecting to WiFi
I: Using dynamic ip
E: WiFi Connection Failed! Rebooting...
Alles anzeigen
I'm lost and seeking some expert advise please. As I'm out of my league and my Google-Fu is failing me.
Many thanks.
Akriss.