1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOLVED Tutorial connection question

Discussion in 'Hardware Support' started by cy.kopath, 3 June 2016.

  1. cy.kopath

    cy.kopath New Member

    RPi1/Zero, RPi2, RPi3
    The tutorial post "Raspberry Pi 3 Mediacenter + Hyperion Ambilight + NO soldering" is great but it now has me a bit worried. It mentions not using over a 100 leds because the connectors can not handle the electrical load. Which connectors do you mean? My guess is you are referring to the connectors used as the 90 degree bend at each corner of the tv. Using 30led/m strips I'd have over 120 leds on my tv. Are there heavier gauge connectors available? (I doubt it or you'd have used them) or could I work around this limitation of the connectors by soldering them?
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    Of course yes! This only a limitation for the 90 degree connectors, the problem is the heat :) If you solder it, you have no problems with it and can use as much as you want
  3. Brindosch

    Brindosch Active Member

    RPi1/Zero, RPi2, RPi3, +nodeMCU/ESP8266
    We should publish a solder tutorial as addition. If people want to do crazy stuff like 60 leds/m we should build our own setup and measure the voltage to ensure the best possible voltage over the whole stripe.