1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Installation with command line

If you want to install Hyperion via command line, just use the following command
Code:
curl -k -L --output install_hyperion.sh --get https://raw.githubusercontent.com/hyperion-project/hyperion/master/bin/install_hyperion.sh
chmod +x install_hyperion.sh
sudo sh ./install_hyperion.sh
If you see no "Critical Error" message, all went good.

Now you need your own created configuration file (hyperion.config.json) that depends on your led hardware/setup. Follow: a) HyperCon Configuration

This page has been seen 12,939 times.