I have tried every debug method but am unable to understand what's wrong with my setup.
It worked fine for a day and then stopped grabbing but LEDs were responding to commands from hypercon.
I did a fresh install by formatting the SD card and reinstalling libreelec.
Ever since then, the LEDs only light a bright white as soon as Hyperion is started and then never change any color.
The logs don’t show any error/warning at all. Also, the logs will show that boot sequence ran when it never did.
Here are all the things I have tried so far:
- I have tried with a couple other smaller spare leftover ws2801 strips as I thought I might have the faulty first LED problem.
- I have tested the SPI of my PI based on this thread and it works fine. (And SPI is enabled in the config files.)
- I have tested with Hyperion NG, the problem stays the same. Bright white LEDS only.
- I have tried running hypercon from different computers with a fresh Java installation.
You can see a recent log file attached.
I also attached my config file with a recent test using only 4 leds
What do you guys think I am missing?
Hardware:
WS2801 LED strips
10A PSU for led strips
RPI 3 b+ powered separately
Software:
Librelec
(And raspian for testing SPI and Hyperion NG)
Wiring:
Ground to pin 9 and PSU
Data to pin 19
Clock to pin 21
Here's a similar problem thread: https://hyperion-project.org/t…or.3224/page-2#post-12512