Dashboard

Ich habe zu LE 10 einen Post gefunden im LE Forum.

Dort gibt es wohl Probleme mit LE 10.0.3 und Hyperion NG

LE 10.0.3 und Hyperion NG

If the system (Rpi) has activated more than one IPv4 interfaces (wlan0 and eth0) Hyperion only offers the web confiuration tool with one (actually at me eth0) address.
Even if then the eth0 interfaces is deactivated (all eth0 configration entries removed)…

I have now watched a couple of hours of material that was very problematic before and the stuttering seems to be completely gone with the trick above. Everything is butter smooth with zero missed vblank updates using 235x180 capture resolution and no…

I've used my own solution with phone camera+hyperion API to adjust all colors (W, R, G, B, C, M, Y):

after having several experience now with diffrent strips and setups:


i would like to add that injecting power on 5volt ledstrips in the middle of the strip above 200 leds ( 60l/mtr types) is really recommended.
I upgraded from APA102 (30l/mtr 130leds) to…

Ok so Ive replaced the raspberry pi and it’s a lot better now it’s basically working now apart from the odd flash of like rainbow colours every ten seconds or so

---

I’ve soldered the data line to gpio 18 and have 3 grounds connected also which are not…

sk6812 need a levelshifter to boost digital signals from Raspi GPIO to the leds

They cost around 5 bucks on AliExpress

---

and have more common ground pins (GND) used on the Raspi, at least 2

---

€ 1,96 12%OFF | Tzt 10Pcs 4 Kanaals Iic I2C Logic Level Converter…

Hello and thanks in advance for any help you can provide!

I've just built a large setup for a projector screen and nothing seems to be working, I've attached a sketch of my hardware setup for reference.:

SK6812 RGBW LED - 60/m, total of 490 LEDs (158…

[…]

my mistake, i read Raspi so was fast automatic reply

my apologies

I've used my own solution with phone camera+hyperion API to adjust all colors (W, R, G, B, C, M, Y):