Issues Getting Hyperion to Install/Run

Nikhil · 13. April 2017

Zitat von episcop

Hi for all. Have Rpi3, arduino nano, ws2812b, UTV007. Try any tutorials wihtout success. Try osmc, OE, LE, with arduino(any sketch,any prefix) and without, with level shifter(make bss138 and 10k resistors, powerd 5v only). Power suplay 5.15v, di line 270ohm resistor. Arduino with sketch adalight and ambibox work fine, not hardware, with osmc hyperion running, have transmition into arduino(led RX blinkig fast), strip nosing...utv007&arduino recognised as video0&usb0, hyprioncon conected ssh. Any solution before I'm bomb?

1. What driver are you using? SPI, PWM, Adalight?
2. What is the amperage limit for your power supply?
3. Have you tried a 100ohm resistor instead of the 270ohm?

episcop · 14. April 2017

1. With arduino - adalight, direct - ws281x.(into HyperCon)
2. Power suplay 5A for strip, and 2A for Rpi3.
3. Try direct, lewel shifter, 220ohm.
On LE&osmc need edit config.txt?

episcop · 17. April 2017

Solved. My errors: when using PWM driver direct gpio - have HDMI unpluged, output have noise(looking oscilogramme). After, using arduino and sketch from this forum. Work only test color via ssh. Grabber external not working, because in HyperCon grabber tab internal box cheked & have priority of external. After configuration all ok.

Jetzt mitmachen!