Beiträge von taconapsack

Thanks for the link. I tried to go through that, but it looks like my dialout group user is root and openelec doesn't really have the capability built in to allow me to create new users or change anything.

Any update on this? I am having a similar issue and was wondering if you solved the problem.

Before plug in: [MEDIA=pastebin]svTV6kHR[/MEDIA]
After plug in: [MEDIA=pastebin]Y4GN2ug3[/MEDIA]

Here is the response to that. It looks like ttyACM0 is the proper port.

[MEDIA=pastebin]xY7y29PT[/MEDIA]

Quick synopsis of the issue: I installed Hyperion and is seems to be connecting and pushing commands, but I don't even see the bootup light sequence.

I attempted to set up the ambilight system with the HDMI video capture. I have the following setup:
WS2812B LEDs (192 of them) connected to a 12A power supply > Arudino (Pin 6 for Data and then Ground pin)
Arduino > Pi2 with OpenELEC (5.0)

I can get sketches to run, the bootup (all lights flash once each color) for the sketch on the tutorial page (https://hyperion-project.org/t…-ws2801-ws2812b-apa102.8/) is working.

I installed Hyperion using the guide as well and there were no errors. I updated the hyperion config with the required information (link below). But I cannot get any commands to go through from the desktop client or the remote. The bootup rainbow swirl sequence also does not trigger.

I can see the Arduino R3 on the usbports as well as the video cap device.
Bus 001 Device 005: ID 1b71:3002 Fushicai USBTV007 Video Grabber [EasyCAP]
Bus 001 Device 004: ID 2341:0001 Arduino SA Uno (CDC ACM)
Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. SMSC9512/9514 Fast Ethernet Adapter
Bus 001 Device 002: ID 0424:9514 Standard Microsystems Corp. SMC9514 Hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

Log File: [MEDIA=pastebin]BiUY0pXv[/MEDIA]
Config File: [MEDIA=pastebin]AjdRhY6J[/MEDIA]
Thanks in advance for any help.