Beiträge von FuzzyMistborn

Figured out my issue. Swear I was running Hyperion as root but apparently I was not. Once I was running as root, things worked as expected.

Forgot to mark resolved.

So the 5v/ground to the pi is necessary? What setting on the Pi do I need?

Cross post from https://github.com/hyperion-pr…erion.ng/discussions/1362

I feel like I must be missing something obvious here. Currently I run Hyperion on a Pi and then use WLED to directly drive the LEDs themselves (WS2812B's). It works mostly OK but the wifi lag on the ESP/WLED is annoying and I get occasional disconnects. Thinking of wiring the Pi in directly to the LEDs.

Currently i wire my ESP like I have in the attached picture. The main difference is I power the ESP board over the USB, so no 5v/ground from the power supply to the ESP board. Basically 3v, ground, and a data wire go from the ESP through a logic level shifter (low side for the ESP, high to the power supply) to the LEDs. The issue is when I unplug from the ESP and move the wires to the Pi (same thing, 3v, ground, and to GPIO 18) I get nothing. Can't even do a manual effect/control the LEDs that way. I've change the setting in Hyperion to "ws281x" for LED controller type, clicked save...nothing. Do I need to set something on the Pi for it to work? Install something?