Beiträge von lsaadeh

Zitat von Lightning-guy77

i did this also to test, and the link at Github is just the same than blacklist led's in the configurator.

i compare the Json outcome from either of them and resulted the same. > Hyperion 2.012

can you share your ledconfig from the webpage and Json? it helps otherss that are struggling with this.

I just did a comparison on the blacklist version vs the version I created by manually adding off leds.

Most the differences are with these values which is why I think I'm able to achieve the desired effect:

I've uploaded the configuration which works for me.. the leds used have been tweaked to get a better alignment for my situation. I'm now using 80 leds in the middle and deactivating 14 leds on either side.

so I applied the workaround and added the amount of offset pixel I need and it's working very well now. only wish there was an offset option in the ui to apply this workaround without needing to go in the json file

blacklisting the leds seems to play the light effects over the same amount of leds but just seems to cut or blacken out the leds selected. what I'm trying to accomplish is have the length of the led effects shortened to span over the middle 76 leds if that makes sense. blacklisting the first and last 16 leds still causes the lighting effects to be misaligned with the tv.

Looks like the feature doesn't exist but someone found a hacky way to make it happen https://github.com/hyperion-pr…41#issuecomment-761579372.. this should be a feature imo.

Hey Lightning-guy77, for my current set up I only have 1 led strip (108 leds) that runs along the back of my tv stand (not on the back of my tv) which I use for static ambient light when I'm not using them for hyperion and they are used to simulate the bottom leds in hyperion. my tv stand is longer than my tv and the strip overlaps the tv on either side by 16 leds. So I have set my bottom in Hyperion to be 76 leds BUT I need to offset the start position to be 16 leds so that it displays the effects of the leds in the middle of the strip to be in line with the tv, using the full 108 leds cause the effect to be to wide and misaligned with the tv on either ends. I would like to configure the first 16 and last 16 leds to not be used and push the effects to the middle of the strip if that makes more sense.

as you can see in the photo.. if I can offset the first led 16 leds to the left it will align with my tv and the length of actives leds will be correct to the size of the tv

I have an led strip that is longer than my tv by 32 leds (16 leds each side).. I've reduced the size of the leds but I now need to offset the start position by 16 leds so the light effect aligns with the tv. How can I offset the start position?