Beiträge von grannymaster

Any idea what could be causing this gradient with certain colors?

Magenda https://i.imgur.com/LdlgytB.jpg

But then other colors like Green https://i.imgur.com/mKtAspq.jpg and Blue https://i.imgur.com/gcDJ66W.jpg work just fine?

Parts I use:
PSU:

LED:

LEDs are connected via GPIO pins.

Installed fresh installation HyperBian, decided to test how it works. After about 10 seconds all the lights are stuck, see the picture below:

https://i.imgur.com/WCmj3Ss.jpg

My logs:

Raspberry Pi and WebUI is fully responsible.

Only thing I've changed is the name of the instance and configured the amount of leds.

After checking status of Pi, I found that the service is reported dead

pi@HyperBian:~ $ sudo systemctl status hyperion@pi.service
● hyperion@pi.service - Hyperion ambient light systemd service  for user pi
Loaded: loaded (/etc/systemd/system/hyperion@.service; disabled; vendor preset: enabled)
Active: inactive (dead)
Docs: https://docs.hyperion-project.org


pi@HyperBian:~ $ journalctl -u hyperion@pi -b
-- Journal begins at Tue 2022-05-24 19:58:13 BST, ends at Thu 2022-08-18 17:18:23 BST. --
-- No entries --

Ambientheater77

Yours is a bit more complicated than mine After looking at your drawings, in theory what I posted above should work.

EDIT: Updated my diagram to make it a bit clearer

https://i.imgur.com/r93ApZ9.png

Thanks for your reply pclin !

So just to make sure, if I do it like this it will work?
https://i.imgur.com/KiTMBqv.png

Part list:

Splitter: https://www.amazon.de/-/en/gp/…?smid=AKUWLJEAO5PBR&psc=1

Capture Card: https://www.amazon.de/-/en/gp/…?smid=AUTSUXCSVPPG2&psc=1

LED Strip: https://www.amazon.de/-/en/gp/…smid=A2CRFKF5XF9GCG&psc=1

Hello and thanks in advance!

I have a Shield Pro which is connected to my LG soundbar via pass-through and then the TV.

My plan is to have HDMI routed like this:

Shield -> LG Soundbar -> HDMI Capture card -> TV

My problem is that I can't find an 4K@60Hz HDMI capture card which would support CEC. Next question after that would be about ATMOS, if the Shield is connected to the soundbar ATMOS should work right? Even thought HDMI capture card doesn't support it.