Hi, I just finished my setup. I was going to configure the LEDs but they didn't turn on ever. Hyperion status shows Stopped. I don't know where should I check. Can anyone help me?
Here you can find the log on expert mode.
Hi, I just finished my setup. I was going to configure the LEDs but they didn't turn on ever. Hyperion status shows Stopped. I don't know where should I check. Can anyone help me?
Here you can find the log on expert mode.
I have the same issue. I am facing that hyperion status Stopped when i open the prompt and login by putty
And Log shows me:
[DAEMON] (ERROR) Lock/unlock handler- Session bus is not connected
Can anyone help me about it?
The below you can find the log
Hyperion Debug log Please.
LED type, OS, etc.
regards pclin
I dont know how to take devug log but led type is ws2812b and i am using putty for connection. I also wonder wiring direction is correct or not in this picture https://i.hizliresim.com/1at1y59.jpeg
Hi everyone. I just completed the Ambilight project with rpi0. I used 5v 10A adaptor which feeds rpi0 and led strip together. When I log in to the raspberrypi:8090 I can see rpi detected the led strip and video capture card. so I assume the data pin is working. But leds didnt light up ever. I checked the voltage at the end of the led strip with a multimeter. There are 5v and 2.5A although my adapter is 10A. Here is my set up. https://imgur.com/a/J7d8NYH Can anyone give me a suggestion?