Beiträge von Malvazar

    Oh, probably should have specified. The tv is wired, the pi is on Wi-Fi. Mostly cause I can't be bothered to run another cable to the pi.

    I will give those setting another try though, thanks.

    Anybody have some advice on how to get PicCap running on an LG tv talking to hyperbian on a rsp3? I had it working over Wi-Fi at one point, but due to a network upgrade everything was changed, and the new information for it seems to not be working. I've got the pi's ip of 192.168.x.x entered and have tried ports 19400, 19440, 19444, and 19445. All without success.... Am I just being a dumb dumb?

    Update

    I was able to get it running as root by using the command console on the pi directly, and figured it that I had my data pin connect to physical pin 18 not gpio 18. Changed it and it works perfectly now. Thanks for trying to help.

    Why don't you use Hyperion on LG TV?

    ESP with WLED to control the LED.


    regards pclin

    Because I'm out of work right now due to a disability, so I'm working with what I have. I tried ambilight on an arduino nano directly connected to the tv via usb, but again got nothing from it. Figured the tv is to old or something got it back in 2015.

    https://docs.hyperion-project.org/en/user/HyperBian.html

    • User: hyperion
    • Password: ambientlight

    sudo updateHyperionUser -u root


    Yeah I did all of that, and used my Linux terminal to ssh over to the pi. It does not ask for the username, and will not accept the password. I pulled the sd out a couple more time to check if I did it right, and noticed the the ssh file keeps disappearing. Not sure if that's normal.

    Okay, so I finally figured out for to forward the output oh the TV instance of Hyperion to my PIs instance.
    However now I can't get it to actually work with my led strip for what ever reason. I'm using a ws2812b, it has three wires Live, Ground, and Data. I've got it wired into the pi with ground on on pin 9, and data on pin 18, power has its own supply separate. I know my strip works, as I've been using it up till now just fine, and the pi works seeing as I'm able to connect to it web server. So I'm really confused why its not doing anything. No response from byte order wizard, or anything ells I could think to try.


    Okay update. I did a little more digging and noticed the log is telling me i need to run HyperBian as root, and to do that I apparently need enable ssh. So I made the empty ssh file on the boot partition, and I can't login. Just getting invalid password.

    Okay, so I've done all the google'ing I can handle. I've got an old DIY Prismaik setup on my LG tv. I saw that with my tv rooted I could run Hyperion on it directly and not have to use my pc anymore, I'd love that. Did some digging and got Hyperion.NG and PicCap installed, and read somewhere that I need a RPi to drive the LEDs.

    So what I can't figure out is how to send the signal from Hyperion on the TV to the Pi, or am I going about this all wrong?