Really sorry 
I was under the impression that the chip was the only important bit. The splitter works really well with my receiver and my tv btw again. i can grab the receivers signals but not behind the splitter.
https://a.aliexpress.com/_EHYnTwl - grabber
https://a.aliexpress.com/_EQr3gZB - splitter
What Info is needed here? MS2109 is the Chip of the grabber. The chip of the switch can be seen in the foto.
I input 1920x1080@60hz into the splitter and it splits correctly to two Monitors. The grabber grabs correctly at 1920x1080@60. Using the grabber behind the splitter has the grabber output a rainbow.
I check the output of the usb grabber from a separate PC with obs.
Could you quickly tell me which info is needed?
the grabber supports in 4k60 and outs in fullhd.
Hi 
I'm encountering a bit of a snag with my Ambilight setup, and I'm hoping someone here might be able to offer some insight. Here's the situation:
Individually, both my capture card and HDMI splitter work perfectly fine. However, when I try to use them together in my test setup, I run into issues. The capture card doesn't seem to recognize the signal when it's passed through the HDMI splitter.
I've tried troubleshooting by adjusting configurations and checking connections, but so far, I haven't had any luck resolving the issue.
If anyone has experienced a similar problem or has any suggestions on how to troubleshoot this, I would greatly appreciate your input. My goal is to get both the capture card and HDMI splitter working harmoniously within my Ambilight setup.
Thank you in advance for any assistance you can provide!
I would also appreciate to know which one is causing the issue and what i would need to rebuy
That is the inside of my splitter
