On the photo you can see that the arduino displays an error about a busy port and it is because of Hyperion, because after closing it the arduino flashes but Process Explorer does not show anything.
Beiträge von wobisi3337
-
-
I read the errors before writing a post on the forum, and all the actions listed by you do not give anything, I will also add a new more detailed log where in the beginning adalight is connected but after a while again refused to dustup for the whole time the tape did not work. LOG
-
I flashed the arduino with this sketch, github
I changed the parameters for my tape, I didn't touch the pin and it is still d6, the photo shows that gnd and d6 of the tape are soldered to the arduino nano to supply the signal, the arduino is powered from the computer, for the tape I took a separate power supply from my computer, the power is enough (5V/22A)
Also provided a video of the connection and that the tape does not work
If you can watch the video here is a link to GDrive, if you know a better service for uploading videos please let me know Video
-
Hello, I have encountered such a problem that the backlight does not work. Arduino nano and tape ws2812b 144/1m. The ribbon flashes after connecting the arduino nano to the computer but then silence and does not light, the sketch installed adalight and in the configuration of the sketch set the length of the ribbon 288 as I have 2m, I thought maybe because the arduino can not process such a number of LEDs and set 60 in the sketch but did not help, the ribbon and arduino working I checked them
Link to log https://pastebin.com/gxkxu5TU