could be anything...why you dont test it?
i dont know how to solve your problem.... which usb grabber do you use?
the easycap one (STK1160)
but i just measured my power supply voltage with my multimeter --> it says 5.5 Volts.
Can this be the flickering issue????
Can my power supply be the faulty one?
Hi it's me again
i have uploaded another video where you can see the flickering issue. If the picture is having a stable image the LED's are doing a good job, but once the colors are moving the flickering starts heavely.
What else can i try.
hmm, did you try to calibrate the colors? or just installed it?
Just installed them
How can i calibrate them
Alles anzeigendid you try it with deactivating the kodi checker?
just remove this part
// KODI CHECK CONFIG
"xbmcVideoChecker" :
{
"xbmcAddress" : "127.0.0.1",
"xbmcTcpPort" : 9090,
"grabVideo" : true,
"grabPictures" : true,
"grabAudio" : true,
"grabMenu" : false,
"grabPause" : true,
"grabScreensaver" : true,
"enable3DDetection" : true
},
i just removed it in the config. It looks like with white brighte colors it works pretty okay. but once colors are there it starts to flicker
can you show me the new screenshot?
okay i did this but this alone does not really solves my problem. hmm i am stuck
yes, BUT that doesnt mean that your ws2801 are bad
but that isnt the problem...cause as you can see the rainbow works flawless...think it is just the config for the usb grabber part...which one do you use? did you made a screenshot to see how the input looks like?
like this one?
first of all thx
It's a bit better but still not as it should i guess.
what did you do? are the apa102 leds better???
the one from your rpi for hyperion
i have uploaded the config files
Which config you need exactly
Hyperion config which i upload??
Hi everybody
i have a problem with my setup as you can see in the videos. When i start hyperion the rainbow works perfectly. Also when i set the led colors through the colorwheel the colors are rocksolid and i can change them accordingly. (Video #1)
But after the system is up and running the leds are flickering and are not corresponding the colors of the displayed live stream (Video #2)
What is wrong and what am i doing wrong.
Preconditions: OSMC is installed through hypersion --> so far all good
My setup/wiring.
Power supply: https://www.aliexpress.com/ite…=a2g0s.9042311.0.0.fPl6cS
LED ws2801: https://www.aliexpress.com/ite…=a2g0s.9042311.0.0.dijuU2
- From the LED strip start the plus(+) and ground cable are connected directly with my 8A power supply.
- The LED strip end i have connected plus and ground again with the power supply.
- The 8A power supply also delivers power to the HDMI splitter
- And i also power the PI through pin 2(5volt) and pin6 (GND)
- From the LED strip start the two other cables (DAT and CLK) i have soldered to pin 19 and 23
--> see pictures
