I set it back to 0 and it still doesn't work. When I disabled all the grabber options I tested it again and for a bit it showed the test lighting. Unfortunately, I'm unable to reproduce this again. When I press on Start button It clears the LEDs if they were on before and then it doesn't do anything.
Hyperion-Log2:
[MEDIA=pastebin]Ay6euDaV[/MEDIA]
hyperion.config.json:
[MEDIA=pastebin]sNL6pRy6[/MEDIA]
Hello,
I have been trying to get the software part to work for quite a long time now, and I can't seem to get it to work.
I have raspberry pi zero with Raspbian Stretch Lite installed on it. On the pin 12 of the pi (GPIO 18) I connected the data pin of WS2812B LED strip. I used HyperCon to install hyperion on the Pi via ssh connection. After that, I uploaded the hyperion.config.json that I generated with this software as well. Then I pressed on start but none of the LEDs lit up. I did get something in the Hyperion-Log. But I can't figure out what I'm doing wrong.
Any help would be appreciated.
Hardware:
LED WS2812B strip
Raspberry Pi Zero W
1X2 HDMI Splitter
HDMI to AV Converter
USB Video Grabber
Hyperion-Log:
[MEDIA=pastebin]XqTeV3Cv[/MEDIA]
hyperion.config.json:
[MEDIA=pastebin]5Kq4zzYk[/MEDIA]
