ys finally is "just" CI and DI wire too long (1.5meter). I make a new with only 30 cm and now is ok.
Beiträge von crunchattak
-
-
Je viens de trouver la solution, cela venait des câbles CI/DI qui étaient trop long. Je viens de faire le changement cela fonction nickel. Me reste plus qu'a acheter un node pour le mettre en sans fils.
Comment passe t-on le post en résolu?
C.
-
Bonjour,
Non j'ai utilisé 272 leds. j'ai aussi essayé avec un fond blanc et je n'ai pas de pb, uniquement les gris. -
Bonjour, j'ai finit mon installation mais je suis confronté à un problème et je ne trouve pas la réponse.
Mon installation est composée de :
Raspberry Pi 3b+ sous RASPBIAN
Dernière version de Hyperion and Hypercon
APA102, 5m, 60 leds/m
Alimentation 10A/50W
UTV007
Je me sers de mon ampli comme splitter (Yamaha rxa850)J'ai tester les différentes couleurs disponible:
hyperion-color-calibration-greylvl-pictures et hyperion-color-calibration-color-pictures.
Je n'ai aucun problème sauf pour le grey_3F3F3F et le grey_7F7F7F ou j'ai des led qui scintillent.J'ai essayé de changer beaucoup de paramètres sans succès comme: horizontal and vertical gap, frame and size decimation, baud rate, RGB order. Update freq.
J'ai aussi essayé avec ces commandes:
hyperion-remote --priority 50 --color red --duration 50000
hyperion-remote --priority 50 --color white --duration 50000
Sans pb
Par contre
hyperion-remote --priority 50 --color gray --duration 50000
Elles clignotent.Voici une vidéo ou je rencontre ce problème:
Externer Inhalt www.youtube.comInhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.Pourriez-vous m'aider?
Un grand merci d'avance,
C. -
Hello, thanks for reply, not working if I change le update freq.
I close this thread to make a new in french. -
Hello excuse for my english (I'm french)
I just finished the installation.
My config is:
Raspberry Pi 3b+
RASPBIAN
Latest Hyperion and Hypercon
APA102, 5m, 60 leds/m
10A/50W PSU:
UTV007
splitter is AV Receiver (rxa850)When I test the different colours, I have no problem.
Some LEDs flicker with grey_3F3F3F and grey_7F7F7F all the rest works super well.
I tried to change many parameters without success such as: horizontal and vertical gap, frame and size decimation, baud rate, RGB order.
I made a short video to better understandExterner Inhalt www.youtube.comInhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.
Do you have any ideas?
Thanks in advance,
C.